The Pitbull® pump is an innovative, simple solution to many of industry's difficult pumping applications.

Using only two check valves and a hollow chamber, the Pitbull will fill and then discharge almost any combination of liquid and solids that can flow through its wide open inlet.

The operation of the Pitbull is automatic unlike conventional pumps, so it will match the cycle rate to the inflow rate, and shut itself off when flow stops without needing level controls.

It uses compressed air as the motive force, acting directly on the liquid without the need for diaphragms or seals. The all-pneumatic operation simplifies installation, eliminates shock hazards and is suitable for explosion-proof areas.

Pitbull® offers a full line of submersible pumps along with sludge transfer, filter press feed and condensate return pumps.

The available flow rates from 2 gpm to 2000 gpm at discharge pressures up to 125 psi.

But the real story is not how much the Pitbull® can pump, but what it can pump... with full pipe diameter passages and low internal velocities, all kinds of solids, trash and abrasives can pass through this pump.

It has no impellers, seals, motors, diaphragms, and no moving parts in contact with the liquid other than two check valves.

Web Address: www.pitbullpumps.com